Make
edges on rounded or straight
edges stronger, safer and more professional in appearance
with Hem Rolls. This easy, three-step process creates hem
rolls approximately 1/4" deep on steel or aluminum
up to 0.040" without marring pre-painted aluminum. Sets below include all 3 steps. See our specialty rolls for the individuals. Click the video icon below each step to see the process.
Wire
Bead Rolls
These roll sets allow you to crimp either a 1/16" or 1/8" diameter wire onto the edge of a panel. This stiffens the panel and is good for fender wells or any place where a stress crack needs to be avoided. This is a 3 step process similar to our Hem Rolls (above). Each Wire Bead Set listed below includes all three roll sets needed to do that particular size.
