|
Creation
of parts can be done in Assembly or using Bend-Tech's standard methods
like; templates, custom part, custom 3D, etc... PRO uses common
terms for design; to front, back, left, right, ceiling and floor.
Parts can be rotated or mirrored at anytime. If a part is created
or altered in Assembly it can be sent back to part design for correct
cut length, bend locations, rotations, angles and simulation.
Dimensioning:
A single part or an entire assembly can be dimensioned. Dimension
types include; horizontal, vertical, linear and angular. Dozens
of settings are available for the dimensions including; colors,
sizes, angles, tolerances, etc....
Notching : PRO
can create a scale template or wrapper for cutting or notching the
ends of your tube. Any number of tubes and sizes of tubes can intersect.
There are 2 calibration lines on the template; linear location and
rotational location.
|
|
